Quality perspective for all your projects




It is a cement-based powder mortar used for bonding tiles and ceramics with reduced slip.


Usage areas:

  • Concrete, plaster, screed, tile, etc. coating tiles and ceramics on it
  • Indoors and outdoors,
  • On horizontal and vertical surfaces,
  • It is used for bonding small and medium sized floor and wall ceramics with a water absorption rate of over 3%.

Preparation of the Surface:

  • Care should be taken that the application surface has cured.
  • The application surface must be cleared of materials that prevent adhesion such as dust, oil, tar, tar, paint, silicone, curing material, detergent and mold oils.
  • Defects on the application surface should be corrected 24 hours before, with suitable repair mortars, depending on the depth and structure of the surface.
  • The application surface should be wetted and ensured to be moist. If the surface is too water absorbent, it should be applied after priming the surface.

Preparation of Mortar:

  • 25 kg of Tile and Ceramic Adhesive Mortar is added into approximately 5.5 – 6.5 liters of clean water and mixed preferably with a low speed mixer until there is no lump.
  • The prepared mortar is left to mature for 5 – 10 minutes and is used by mixing again for 1-2 minutes.
  • The mixture in the pot should be consumed within 1 – 1.5 hours.

Application Information:

  • First of all, a contact layer is formed by pressing the adhesive mortar firmly on the application surface, and then the product is combed with a toothed trowel selected according to the tile size.
  • It should be ensured that the adhesive mortar touches at least 80% of the back of the ceramic.
  • To ensure a good adhesion, apply force with the help of a rubber hammer.

3,5 – 4 kg/m2


  • Avoid application at temperatures below + 5 ° C and above + 35 ° C.
  • Pay attention to the amount of water added to the mortar. Do not add more water than necessary.
  • Avoid application in frozen areas, where there is a risk of freezing within 24 hours or in areas open to direct sunlight and wind.
  • Do not add powder and water to the expired mortar.

In 25 kg craft bags

Shelf life:
It can be stored for 12 months on the pallet in a 10-fold stacked in a dry environment and in its unopened package.

Health and Safety:
As with all chemical products, contact with food products, skin, eyes and mouth should be avoided during use and storage. During the application, work clothes, protective gloves, goggles and masks in accordance with work and worker health rules should be used. If swallowed by accident, consult a doctor. In contact with skin, wash with plenty of water. It should be stored in places out of the reach of children.

Application Temperature:

(+5°C) – (+35°C)

Mixing ratio:

6,5-8 lt water / 25 kg powder 1,3-1,6 lt water/ 5 kg powder

Pot Life:

1-1,5 hours


(EN 1308) ≤ 0,5mm

Open Time (EN 1346):

At least 30 minutes. Then ≥ 0,5 N/mm²

Time to Use:

8 hours on the wall – 1 day on the floor

Consumption Average:

3,5-4 kg/m²


≥ 0,5 N/mm²

After Immersion:

≥ 0,5 N/mm²

After Reconstitution with Heat:

≥ 0,5 N/mm²

After Freeze-Thaw Cycle:

≥ 0,5 N/mm²

Reaction to Fire: